Service Fabric Local Cluster "unable to route request to..." - After upgrading Windows 10 May 2019

  • 1 year ago
Comment

ChatGPTChatGPT
1 / 1

If you are experiencing issues with the Service Fabric Local Cluster after upgrading to Windows 10 May 2019 (version 1903), there are a few troubleshooting steps you can try:

  1. Restart the Service Fabric Local Cluster Manager: Open the Service Fabric Local Cluster Manager and restart the local cluster. Sometimes, a simple restart can resolve connectivity issues.

  2. Check firewall settings: Ensure that the necessary firewall rules are in place to allow communication with the Service Fabric Local Cluster. Check the inbound and outbound rules to ensure that they are properly configured.

  3. Verify network connectivity: Make sure that the network adapter used by the Service Fabric Local Cluster is properly configured and has network connectivity. Check the IP address, subnet mask, and gateway settings to ensure they are correct.

  4. Reset the Local Cluster: If the above steps don't resolve the issue, you can try resetting the Service Fabric Local Cluster. This will remove the existing cluster and recreate it with default settings. To reset the cluster, open a command prompt with administrative privileges and run the following command:

    arduino
    "C:\Program Files\Microsoft SDKs\Service Fabric\ClusterSetup\DevClusterSetup.ps1" -Unregister -Reset

    After running the command, restart your computer and then recreate the Service Fabric Local Cluster using the Local Cluster Manager.

  5. Reinstall Service Fabric SDK: If all else fails, you can try reinstalling the Service Fabric SDK. Download the latest version of the SDK from the Microsoft Download Center and follow the installation instructions.

If the issue persists after trying these steps, it may be helpful to check the Event Viewer for any related error messages or consult the Service Fabric documentation and forums for further assistance.